3BHE019719R0101 GVC736BE101 控制部分根据外部输入信号或内部程序控制电机的转速和转向

Description

3BHE019719R0101 GVC736BE101 控制部分根据外部输入信号或内部程序控制电机的转速和转向

3BHE019719R0101 GVC736BE101 通用型控制器的工作原理是：将外部输入的控制信号转换为对电机的控制电流，并根据电机的运行状态调整电机的运行参数，从而实现对电机的控制。控制器主要由程序计数器、指令寄存器、指令译码器、时序产生器和操作控制器组成，它是发布命令的“决策机构”，即完成协调和指挥整个计算机系统的操作。

此外，通用型控制器还具有以下功能：

检测电机的运行状态，并将信息反馈给控制部分，用于调整电机的运行参数。

将电源部分将外部电源转换为所需的电压和电流，供给其他部分。
控制部分根据外部输入信号或内部程序控制电机的转速和转向。
驱动部分将控制信号转换为对电机的控制电流，从而驱动电机旋转。

3BHE019719R0101 GVC736BE101 通用型控制器主要由以下几个部分组成：

传感器：用于检测过程中的参数，如温度、压力、流量等。
控制器：根据传感器检测到的参数，计算出控制信号并传递给执行机构。
执行机构：根据控制器计算出的控制信号，对过程进行控制。
显示器：显示当前过程的状态和参数。
接口：用于连接控制器与其他设备。
控制器是由传感器、控制器、执行机构、显示器和接口组成。

3BHE019719R0101 GVC736BE101 控制部分根据外部输入信号或内部程序控制电机的转速和转向

The working principle of the 3BHE019719R0101 GVC736BE101 general purpose controller is to convert the external input control signal into the control current of the motor, and adjust the operating parameters of the motor according to the operating state of the motor, so as to achieve the control of the motor. The controller is mainly composed of program counter, instruction register, instruction decoder, timing generator and operation controller. It is a “decision mechanism” that issues commands, that is, to complete the coordination and command of the operation of the entire computer system.

In addition, the universal controller also has the following functions:

The operating state of the motor is detected and the information is fed back to the control part for adjusting the operating parameters of the motor.

The power supply section converts the external power supply into the required voltage and current to supply the other parts.
The control part controls the speed and steering of the motor according to external input signals or internal procedures.
The drive part converts the control signal into the control current to the motor, which drives the motor to rotate.

3BHE019719R0101 GVC736BE101 General purpose controller mainly consists of the following parts:

Sensors: Used to detect parameters in the process, such as temperature, pressure, flow, etc.
Controller: According to the parameters detected by the sensor, the control signal is calculated and transmitted to the actuator.
Actuator: According to the control signal calculated by the controller, the process is controlled.
Monitor: Displays the status and parameters of the current process.
Interface: Used to connect the controller to other devices.
The controller is composed of sensors, controllers, actuators, displays and interfaces.