PM864 简单DIN轨道连接/卸料程序

Description

PM864 简单DIN轨道连接/卸料程序

pm 864控制器的底板有两个RJ45以太网端口(CN1、CN2)用于连接到控制网络，以及两个RJ45串行端口(COM3、COM4)。 中-个串行端口

(COM3)是带有调制解调器控制信号的RS -232C端口,而另- -个端口(COM4)则被隔离并用于连接配置工具。控制器支持CPU冗除以实现高可用性(CPU、CEX总线、通信接口和S800 /O)。
简单DIN轨道连接/卸料程序，使用唯一的滑道&锁机构。所有base plates都有唯一的以太网地址，每个CPU都有一个硬件标识。地址可以在连接到
TP830 base plate的以太网地址标签上找到。

功能与优点：

可靠性和简单故障诊断程序模块化，允许逐步扩展IP20类保护，不需要存储模块
控制器可配置为800xA control builder
控制器已获得完整的EMC认证
使用BC810对断开CEX总线基于标准的硬件，用于实现最佳通信连接以太网、PROFIBUS DP等。)
内置冗馀以太网通信端口

PM864 简单DIN轨道连接/卸料程序

The baseplate of the pm 864 controller has two RJ45 Ethernet ports (CN1, CN2) for connecting to the control network, and two RJ45 serial ports (COM3, COM4). Medium – one serial port

(COM3) is the RS-232C port with the modem control signal, while another port (COM4) is isolated and used to connect to the configuration tool. The controller supports CPU redundancy division for high availability (CPU, CEX bus, communication interface, and S800 /O).
Simple DIN rail connection/discharge procedure with unique slide & lock mechanism. All base plates have a unique Ethernet address, and each CPU has a hardware ID. The address can be in the connection to
Found on the TP830 base plate’s Ethernet address tag.

Features and Benefits:

Reliability and simple fault diagnosis procedures are modular, allowing the gradual expansion of IP20 class protection without the need for storage modules
The controller can be configured as 800xA control builder
The controller has obtained full EMC certification
Using the BC810 pair to disconnect the CEX bus is based on standard hardware and is used to achieve optimal communication connections over Ethernet, PROFIBUS DP, etc.)
Built-in redundant Ethernet communication port