PM864A ABB 控制器

Description

pm 864控制器的底板有两个RJ45以太网端口(CN1、CN2)用于连接到控制网络,以及两个RJ45串行端口(COM3、COM4)。其中-个串行端口(COM3)是带有调制解调器控制信号的RS-232C端口，而另-个端口(COM4)则被隔离并用于连接配置I具。控制器支持CPU冗除以实现高可用性(CPU、CEX总线、通信接口和S800 /O)。简单DIN轨道连接/卸料程序，使用唯一的滑道&锁机构。所有base plates都有唯一的以太网地址， 每个CPU都有一个硬件标识。 地址可以在连接到TP830 base plate的以太网地址标签上找到。

可靠性和简单故障诊断程序
模块化，允许逐步扩展
IP20类保护，不需要存储模块
控制器可配置为800xA control builder
控制器已获得完整的EMC认证
使用BC810对断开CEX总线
基于标准的硬件，用于实现最佳通信连接(以太网、PROFIBUS DP等)。)
内置冗除以太网通信端口

PM864A

The base plate of the pm 864 controller has two RJ45 Ethernet ports (CN1, CN2) for connecting to the control network, as well as two RJ45 serial ports (COM3, COM4). One of the serial ports (COM3) is an RS-232C port with a modem control signal, while the other port (COM4) is isolated and used to connect to the configuration I device. The controller supports CPU redundancy divided by high availability (CPU, CEX bus, communication interface, and S800/O). Simple DIN rail connection/unloading program, using a unique slide and lock mechanism. All base plates have a unique Ethernet address, and each CPU has a hardware identifier. The address can be found on the Ethernet address label connected to the TP830 base plate.
Reliability and simple fault diagnosis program
Modular, allowing for gradual expansion
IP20 class protection, no storage module required
The controller can be configured as an 800xA control builder
The controller has obtained complete EMC certification
Using BC810 to disconnect the CEX bus
Standard based hardware for optimal communication connections (Ethernet, PROFIBUS DP, etc.)
Built in redundant Ethernet communication port